Radio Antenna Module Replacement (Utility)

Fig 1: View Of Radio Antenna Module & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Remove the right lock pillar garnish molding. Refer to Body Lock Pillar Garnish Molding Replacement (Avalanche/Escalade EXT) or Body Lock Pillar Garnish Molding Replacement (Suburban/Yukon XL/Escalade ESV) or Body Lock Pillar Garnish Molding Replacement (Tahoe/Yukon/Escalade) . Remove the screw from the HVAC duct and reposition the duct away from the module to allow access. Remove the right rear quarter trim panel. Refer to Trim Panel Replacement - Rear Quarter - Right (Extended Wheelbase) or Trim Panel Replacement - Rear Quarter - Right (Standard Wheelbase) .
1	Radio Antenna Module Bolt NOTE: Refer to Fastener Notice . Tighten: 9 N.m (80 lb in)
2	Radio Antenna Ground Strap Screw Tighten: 2 N.m (18 lb in)
3	Radio Antenna Module Tip: Slide the module up to release module retainers from the key slot. Disconnect the electrical connectors. Disconnect the antenna leads to the window. Use a small flat-bladed screw driver or pick tool to release the plastic retaining tab tongue on cable. The retaining clip is not removable after glass installation, caution must be used to ensure it is not broken.