LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2007 >> Escalade EXT >> Repair and Diagnosis (Single Page) >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Diagnostic Information and Procedures >> DTC B1405 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the battery current sensor.
  2. Ignition OFF, test for less than 1 ohm of resistance between the low reference circuit terminal B and ground.
    • If greater than the specified range, test the low reference circuit for an open/high. If the circuit tests normal, replace the BCM.
  3. Ignition ON, test for 5 volts between the battery current sensor supply voltage circuit terminal A and ground.
    • If less than the specified range, test the battery current sensor supply voltage circuit for a short to ground or an open/high resistance. If the circuit tests, normal replace the BCM.
  4. Test for 5 volts between the battery current sensor signal circuit and ground.
    • If less than 5 volts, test the battery current sensor signal circuit terminal C for a short to ground or an open/high resistance. If the circuit tests normal, replace the BCM.
  5. If all circuits test normal, test or replace the battery current sensor.
scientia non olet · About LEMON Manuals