Removal Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Refer to Brake Dust Caution .

Fig 1: Wheel Speed Sensor Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
Disconnect the wheel speed sensor electrical connector (1).
Remove the wheel speed sensor wire harness clips (2) from the stabilizer bar bracket.

Fig 2: View of Wheel Speed Sensor Wire Harness Clip

Courtesy of GENERAL MOTORS CORP.

Remove the wheel speed sensor wire harness clip (1) from the steering knuckle.

Fig 3: Wheel Speed Sensor Bolt

Courtesy of GENERAL MOTORS CORP.

Thoroughly clean the wheel speed sensor mounting area of the steering knuckle of any dirt and debris.
Remove the wheel speed sensor bolt (1).

Fig 4: Wheel Speed Sensor

Courtesy of GENERAL MOTORS CORP.

Remove the wheel speed sensor (1) from the steering knuckle.