Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Position the radio in the vehicle.

Fig 1: Locating Electrical/Audio And Antenna Cable Connectors

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connectors and the antenna.

Fig 2: View of Radio & Screws

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the radio screws.
Tighten: Tighten the screws to 2.5 N.m (22 lb in).
Install the I/P center trim bezel. Refer to Instrument Panel Accessory Bezel Replacement .
Set up the radio. Refer to Control Module References for programming and setup information.