Circuit/System Testing
IMPORTANT:
When removing connectors inspect for damage or corrosion. Damage or corrosion in the following requires repair or replacement of the affected component/connector.
- The information center telltale assembly indicator (rear)
- The object alarm module
- The object alarm module wiring harness connector
- The rear information center telltale assembly indicator wiring harness connector
- Ignition OFF, disconnect the object alarm module connector.
- Test the object alarm module switch disable signal circuit at the object alarm module connector for a short to ground. Verify that a short to ground does not exist.
- If the above condition is found, disconnect the object alarm module switch and re-test. Make the appropriate repair.
- If a short to ground is not found, replace the object alarm module. After replacement and programming refer to Repair Verification .