Test Description
The number below refers to the step number on the diagnostic table.
- 2: This step checks that the VCIM is sending out the proper supply voltage.
DTC B2455
| Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
| Schematic Reference: OnStar Schematics Connector End View Reference: Entertainment/Communication Component Views |
||||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | - | Go to Step 2 | Go to Diagnostic System Check - Vehicle |
| 2 |
|
9 V | Go to Step 4 | Go to Step 3 |
| 3 | Test the cellular microphone signal circuit for a short to voltage. Refer to Circuit Testing
and Wiring Repairs
. Did you find and correct the condition? |
- | Go to Step 9 | Go to Step 6 |
| 4 | Test the drain wire circuit for an open. Refer to Circuit Testing
and Wiring Repairs
. Did you find and correct the condition? |
- | Go to Step 9 | Go to Step 5 |
| 5 | Inspect for poor connections at the harness connector of the cellular microphone and harness connector of the vehicle communication interface module (VCIM). Refer to Testing for Intermittent Conditions and Poor Connections
andConnector Repairs
. Did you find and correct the condition? |
- | Go to Step 9 | Go to Step 7 |
| 6 | Inspect for poor connections at the harness connector of the VCIM. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
. Did you find and correct the condition? |
- | Go to Step 9 | Go to Step 8 |
| 7 | Replace the cellular microphone. Refer to Mobile Telephone Microphone Replacement . Did you complete the replacement? |
- | Go to Step 9 | - |
| 8 | Replace the VCIM. Refer to Control Module References
for replacement, setup, and programming. Did you complete the replacement? |
- | Go to Step 9 | - |
| 9 |
|
- | Go to Step 2 | System OK |