Circuit/System Testing
- Disconnect the door switch connector C1.
- Ignition ON, verify that a test lamp connected to ground does not illuminate when connected to either of the motor control circuit terminals in the harness connector.
- If the test lamp illuminates repair the affected control circuit for a short to voltage.
- Verify that a test lamp connected to battery voltage does not illuminate when connected to either of the motor control circuit terminals in the harness connector.
- If the test lamp illuminates repair the affected control circuit for a short to ground.
- Using a DMM verify that the resistance between the control circuit terminals in the harness connector is greater than 5 ohms.
- If the resistance is less than 5 ohms replace the affected power window motor.
- If all the circuits test normal replace the affected door switch.