Installation Procedure

If removed, install the EBCM. Refer to Electronic Brake Control Module Replacement (W/JL4) or Electronic Brake Control Module Replacement (W/O JL4) .

Fig 1: View Of BPMV, Mounting Nuts & Grommets

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the retaining nuts (2) to the BPMV (3).
Tighten: Tighten to 9 N.m (80 lb in).

Fig 2: View Of BPMV & Bracket Assembly

Courtesy of GENERAL MOTORS CORP.

Position the BPMV and bracket assembly (13) to the frame.
Slide the BPMV assembly toward the rear of the vehicle.
Install the BPMV bracket bolts (12).
Tighten: Tighten the bolts to 22 N.m (16 lb in).

Fig 3: View Of Front Brake Pipes & Fittings

Courtesy of GENERAL MOTORS CORP.

Position the front brake pipes (11) to the BPMV (6).
Install the front brake pipe fittings (10).
Tighten: Tighten the fittings to 18 N.m (13 lb ft).

Fig 4: View Of BPMV & Components

Courtesy of GENERAL MOTORS CORP.

Position the front brake pipe (8) to the BPMV.
Install the front brake pipe fitting (7).
Tighten: Tighten the fitting to 18 N.m (13 lb ft).
Position the retaining clip (9) to the frame.

Fig 5: View Of BPMV & Components

Courtesy of GENERAL MOTORS CORP.

Position the rear brake pipes (3) and (5) to the BPMV (6).
Install the rear brake pipe fittings (2) and (4).
Tighten: Tighten the fittings to 18 N.m (13 lb ft).
Position the retaining clip (1) to the frame.
Connect the EBCM electrical connector.
Bleed the BPMV. Refer to Antilock Brake System Automated Bleed Procedure (W/JL4) or Antilock Brake System Automated Bleed Procedure (W/O JL4) .