Installation Procedure
- Install the battery.
- Install the battery hold down retainer and bolt.
Tighten: Tighten the bolt to 25 N.m (18 lb ft).
- Install the front fender rear upper brace and bolts.
Tighten: Tighten the bolts to 9 N.m (80 lb in).
- Position the starter solenoid cable to the battery.
- Install the starter solenoid cable to the positive battery terminal.
- Tighten the starter solenoid cable nut (5).
Tighten: Tighten the nut to 17 N.m (13 lb ft).
- Close the starter solenoid cable cover at the positive battery terminal.
- Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
NOTE:
Refer to Fastener Notice
.