LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2007 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1032 (Lighting Systems) >> Diagnostic Information and Procedures >> DTC B257A >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the headlamp switch.
  2. Ignition ON, verify the scan tool headlamp switch parameter is inactive.
    • If not the specified value, test the signal circuit terminal 1 for a short to ground. If the circuit tests normal, replace the BCM.
  3. Install a 3A fused jumper wire between the signal circuit terminal 2 and the low reference circuit terminal 8. Verify the scan tool park lamp switch parameter is active.
    • If not the specified value, test the park lamp switch signal circuit for an open/high resistance. If the circuit tests normal, replace the BCM.
  4. If all circuits test normal, test or replace the headlamp switch.
scientia non olet · About LEMON Manuals