LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2007 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1032 (Lighting Systems) >> Diagnostic Information and Procedures >> DTC B2580 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector X4 at the BCM.
  2. Low beam headlamps ON, verify the high beam headlamps are not on.
    • If the high beam headlamps are on, test the high beam relay control circuit for a short to ground. If the circuit tests normal replace the underhood fuse block.
  3. Install a 10A fused jumper wire between the relay control circuit terminal 16 and ground. Verify the high beam headlamps are on.
    • If the high beam headlamps are not on, test the high beam relay control circuit for a short to voltage or an open/high resistance. If the circuit tests normal replace the underhood fuse block.
  4. If all circuits test normal, replace the BCM.
scientia non olet · About LEMON Manuals