LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2007 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1146 (Cellular System, Entertainment System, And Navigation System) >> Diagnostic Information and Procedures >> Speaker Malfunction >> Circuit/System Testing >> Speaker Circuit Malfunction - with Amplifier
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Speaker Circuit Malfunction - with Amplifier

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, inspect the appropriate speaker and the surrounding interior trim for proper and secure mounting. Improper speaker mounting or loose trim may cause an audible buzz or distortion.
    • If the speaker or surrounding interior trim is found to be loose or improperly secured, correctly secure the item.
  2. Disconnect the X2 and X3 harness connectors at the amplifier.
  3. Radio ON, test for 5.0-7.5 volts between the appropriate signal circuit terminal listed below and ground.
    • Left front door or tweeter - Connector X2, terminal 3
    • Right front door or tweeter - Connector X2, terminal 1
    • Left rear speaker - Connector X2, terminal 7
    • Left rear subwoofer - Connector X3, terminal 3
    • Right rear speaker - Connector X2, terminal 5
    • Right rear subwoofer - Connector X3, terminal 2
    • If greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the radio.
    • If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the radio.
  4. Radio ON, test for 5.0-7.5 volts between the appropriate signal circuit terminal listed below and ground.
    • Left front door or tweeter - Connector X2, terminal 4
    • Right front door or tweeter - Connector X2, terminal 2
    • Left rear speaker - Connector X2, terminal 8
    • Left rear subwoofer - Connector X3, terminal 7
    • Right rear speaker - Connector X2, terminal 6
    • Right rear subwoofer - Connector X3, terminal 6
    • If greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the radio.
    • If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the radio.
  5. Ignition OFF, connect the X2 and X3 harness connectors at the amplifier. Disconnect the harness connector at the appropriate speaker.
  6. Radio ON, test for 5.0-7.5 volts between the signal circuit terminal A and ground.
    • If greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the amplifier.
    • If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the amplifier.
  7. Test for 5.0-7.50 volts between the signal circuit terminal Band ground.
    • If greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the amplifier.
    • If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the amplifier.
  8. If all circuits test normal, test or replace the speaker.
scientia non olet · About LEMON Manuals