LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2007 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1219 (Wiper System & Washer System) >> Diagnostic Information and Procedures >> DTC B3875 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the X5 harness connector at the BCM.
  2. Install a 10A fused jumper wire between the WIPER 1 relay control circuit terminal 20 and B+.
  3. Ignition ON, verify that the high speed wipers are not on.
    • If the high speed wipers are on, test the WIPER 2 relay control circuit terminal 21 for a short to ground. If the circuit tests normal, replace the underhood fuse block.
  4. Install a 10A fused jumper wire between the WIPER 2 relay control circuit terminal 21 and ground. Verify the high speed wipers are on.
    • If the low speed wipers are not on, test the relay control circuit for a short to voltage or an open/high resistance. If the circuit tests normal replace the underhood fuse block.
  5. If all circuits test normal, replace the BCM.
scientia non olet · About LEMON Manuals