LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2007 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1219 (Wiper System & Washer System) >> Diagnostic Information and Procedures >> Windshield Wiper Washer System Malfunction >> Circuit/System Verification
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Verification

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON, observe the scan tool Windshield Washer Switch parameter while pressing and releasing the washer switch. The reading should change between Active and Inactive.
    • If the reading does not change between the specified values, refer to the Windshield Washer Switch Circuit Test below.
  2. Connect a test lamp between the relay side of the FRT WASH fuse and ground.
  3. Ignition ON, verify that the test lamp turns ON and OFF while pressing and releasing the windshield washer switch.
    • If the test lamp does not turn ON and OFF while changing between the commanded states, refer to the Windshield Washer Pump Relay Control Circuit Test below.
  4. If the washer pump does not operate, refer to the Windshield Washer Pump Circuit Test below.
scientia non olet · About LEMON Manuals