Windshield Wiper System Module Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Windshield Wiper System Module

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Remove the wiper arms. Refer to Windshield Wiper Arm Replacement (Flat Blade ) or Windshield Wiper Arm Replacement (Conventional) or Windshield Wiper Arm Replacement (Chevrolet Tahoe Two-mode Hybrid) . Remove the air inlet grille panels. Refer to Air Inlet Grille Panel Replacement .
1	Windshield Wiper System Module Assembly Bolt (Qty: 3) NOTE: Refer to Fastener Notice . Tighten: 9 N.m (80 lb in)
2	Windshield Wiper System Module Assembly Tip: Raise the module and disconnect the electrical connector.

Callout

Component Name

Preliminary Procedure

Remove the wiper arms. Refer to Windshield Wiper Arm Replacement (Flat Blade ) or Windshield Wiper Arm Replacement (Conventional) or Windshield Wiper Arm Replacement (Chevrolet Tahoe Two-mode Hybrid) .
Remove the air inlet grille panels. Refer to Air Inlet Grille Panel Replacement .

Windshield Wiper System Module Assembly Bolt (Qty: 3)

NOTE: Refer to Fastener Notice .

Tighten: 9 N.m (80 lb in)

Windshield Wiper System Module Assembly
Tip: Raise the module and disconnect the electrical connector.