Circuit/System Testing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Refer to DTC B3794 before performing this diagnostic, if this code is set as current or history.
- Ignition OFF, disconnect the harness connector at the steering wheel controls switch - left.
- Ignition ON, verify that a test lamp illuminates between the signal circuit terminal 9 and B+.
- If the test lamp does not illuminate, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the BCM.
- If all circuits test normal, test or replace the steering wheel controls switch - left.