LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2007 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1344 (Lighting Systems) >> Diagnostic Information and Procedures >> DTC B2625 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the appropriate component.
  2. Connect a test lamp between the listed LED dimming control circuit terminal and ground.
    • IP multifunction switch terminal 6
    • 4wd mode switch terminal 4
    • PTO switch terminal 7
  3. Command the dimming test high to low with a scan tool. The test lamp should turn from bright to dim when changing between the commanded states.
    • If the test lamp is always OFF, test the control circuit for an open/high resistance or short to ground. If the circuit tests normal, replace the BCM.
    • If the test lamp is always bright, test the control circuit for a short to voltage. If the circuit tests normal, replace the BCM.
  4. If all circuits test normal, test or replace the appropriate component.
scientia non olet · About LEMON Manuals