Circuit/System Testing
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the GDO.
- Ignition OFF, test for less than 1 ohm of resistance between the ground circuit terminal 3 and ground.
- If greater than the specified range, test the ground circuit for an open/high resistance.
- Ignition ON, verify a test lamp illuminates between the B+ circuit terminal 1 and ground.
- If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.
- Hold the 2 outer buttons on the GDO until the LED stops flashing. Place the J 41540
adjacent to the GDO and individually press each button of the GDO. The tester should indicate when each button is pressed.
- If one or more of the buttons does not respond when each button is pressed, replace the GDO.
- Program the GDO with the customer's device. The GDO should learn the device.
- If the device is not learned, a possible rolling code or incompatibility with the GDO receiver will prevent programming. Contact 1-800-355-3515.