Circuit/System Testing
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the electronic compass module.
- Ignition OFF, test for less than 5.0 Ω between the ground circuit terminal 2 and ground.
- If greater than the specified range, test the ground circuit for an open/high resistance.
- Ignition ON, verify a test lamp illuminates between the ignition voltage circuit terminal 1 and ground.
- If the test lamp does not illuminate, test the ignition voltage circuit for a short to ground or an open/high resistance.
- Test for 6.0-7.0 volts between the LIN bus circuit terminal 3 and ground.
- If greater than the specified range, test the LIN bus circuit for a short to voltage. If the circuit tests normal, replace the BCM.
- If less than the specified range, test the LIN bus circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the BCM.
- If all circuits test normal, replace the electronic compass module.