Component Testing
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the appropriate window motor.
- Ignition ON, install a 25A fused jumper wire between the control terminal A and 12 volts. Momentarily install a jumper wire between the control terminal B and ground. The window motor should perform the UP function.
- If the function does not perform as specified, replace the window motor.
- Reverse the jumper wires; the window motor should perform the DOWN function.
- If the function does not perform as specified, replace the window motor.