LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2007 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1642 (Power Steering System) >> Repair Instructions >> Steering Gear Boot Replacement (HP2) >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Steering Gear Boot Components
    GM461496Courtesy of GENERAL MOTORS CORP.
  1. Position the inner boot clamp onto the steering gear boot (3).
  2. Apply grease to the steering linkage inner tie rod (1) and to the steering gear (5).
  3. Install the steering gear boot onto the steering linkage inner tie rod.
  4. Ensure the steering gear boot is not twisted, puckered, or improperly folded.
  5. Install the steering gear boot onto the steering gear. Seat the steering gear boot in the groove on the steering gear housing (4).
  6. Install the inner boot clamp to the steering gear boot.
  7. Install the outer boot clamp (2) to the steering gear boot.
  8. Install the steering linkage inner tie rod nut to the steering linkage inner tie rod.
  9. Install the steering linkage outer tie rod. Refer to Steering Linkage Outer Tie Rod Replacement .
scientia non olet · About LEMON Manuals