LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2007 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1670 (Cruise Control System) >> Diagnostic Information and Procedures >> DTC B3794 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the steering wheel controls switch - left.
  2. Ignition ON, test for B+ between the B+ circuit terminal 1 and ground.
    • If less than the specified value, test the circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the BCM.
  3. Test for B+ between the B+ circuit terminal 1 and the signal circuit terminal 3.
    • If less than the specified value, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the BCM.
  4. Ignition OFF, disconnect the X1 harness connector at the BCM.
  5. Test for infinite resistance between the signal circuit terminal 3 and ground.
    • If less than the specified value, test the signal circuit for a short to ground.
  6. If all circuits test normal, test or replace the steering wheel control switch-left.
scientia non olet · About LEMON Manuals