LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2007 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1670 (Cruise Control System) >> Diagnostic Information and Procedures >> DTC P0571 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the stop lamp switch.
  2. Ignition ON, test for B+ between the B+ circuit terminal B and ground.
    • If less than the specified value, test the B+ circuit for a short to ground or an open/high resistance.
  3. Verify the BPP Circuit Signal data parameter displays released.
    • If not the specified value, test the signal circuit for a short to voltage. If the circuit tests normal, replace the ECM.
  4. Connect a 3A fused jumper between the B+ circuit terminal B and the signal circuit terminal A. Verify the BPP Circuit Signal data parameter displays applied.
    • If not the specified value, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the ECM.
  5. If all circuits test normal, test or replace the stop lamp switch.
scientia non olet · About LEMON Manuals