LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2007 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1855 (Power Steering System) >> Repair Instructions >> Steering Gear Boot Replacement (HP2) >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Inner Tie Rod, Boot And Clamp
    GM461496Courtesy of GENERAL MOTORS CORP.
  1. Position the inner boot clamp onto the steering gear boot (3).
  2. Apply grease to the steering linkage inner tie rod (1) and to the steering gear (5).
  3. Install the steering gear boot onto the steering linkage inner tie rod.
  4. Ensure the steering gear boot is not twisted, puckered, or improperly folded.
  5. Install the steering gear boot onto the steering gear. Seat the steering gear boot in the groove on the steering gear housing (4).
  6. Install the inner boot clamp to the steering gear boot.
  7. Install the outer boot clamp (2) to the steering gear boot.
  8. Install the steering linkage inner tie rod nut to the steering linkage inner tie rod.
  9. Install the steering linkage outer tie rod. Refer to Steering Linkage Outer Tie Rod Replacement .
scientia non olet · About LEMON Manuals