Section 2029 (Front Drive Axle)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Component Locator
- Diagnostic Information and Procedures
- Symptoms - Front Drive Axle
- Front Drive Axle Noises
- Noisy in Drive
- Noisy When Coasting
- Intermittent Noise
- Constant Noise
- Noisy on Turns
- Front Drive Axle Bearing Wear (Straight)
- Front Drive Axle Bearing Wear (Tapered)
- Four-Wheel Drive Does Not Engage
- Four-Wheel Drive Does Not Disengage
- Front Axle Lubricant Leak Diagnosis
- Repair Instructions
- Front Axle Lubricant Replacement
- Vent Hose Replacement (9.25 inch Axle)
- Front Axle Vent Hose Connector Replacement (9.25 Inch Axle)
- Front Drive Axle Inner Shaft Seal Replacement - Right Side
- Front Drive Axle Inner Shaft Seal Replacement - Left Side
- Front Drive Axle Inner Shaft and Inner Shaft Housing Replacement
- Front Drive Axle Clutch Fork Replacement
- Front Drive Axle Clutch Shaft Bearing Replacement
- Front Drive Axle Inner Shaft Seal and Inner Shaft Bearing Replacement (8.6/ 9.25 Inch Axle)
- Front Drive Axle Actuator Replacement
- Front Differential Drive Pinion Gear Yoke Replacement
- Differential Carrier Bushing Replacement
- Differential Carrier Assembly Replacement (9.25 inch)
- Front Differential Carrier Bracket Replacement
- Front Axle Lubricant Level Inspection (9.25 Inch Axle)
- Front Drive Axle Clutch Fork Inspection
- Inner Axle Shaft Shim Adjustment (8.6 9.25 Inch Axles)
- Differential Carrier Assembly Disassemble (9.25 Inch Axle)
- Front Differential Case Disassemble (9.25 Inch Axle)
- Differential Case Bearings Inspection
- Differential Case and Gears Inspection
- Pinion and Ring Gear Inspection
- Thrust Washers, Shims, and Adjuster Sleeves Inspection
- Front Differential Case Assemble (9.25 Inch Axle)
- Front Differential Drive Pinion Gear Bearing Cup Installation (9.25 Inch Axle w/J 45754)
- Pinion Depth Adjustment (8.6, 9.25 Inch Axle)
- Differential Carrier Assembly Assemble (9.25 Inch Axle)
- Backlash Inspection and Adjustment
- Differential Carrier Assembly Final Assembly (8.25 S4WD and 9.25 Lock Tab)
- Differential Carrier Assembly Final Assembly (8.25 Inch axle Lock Ring Type)
- Gear Tooth Contact Pattern Inspection
- Description and Operation
- Special Tools and Equipment