LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2007 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 540 (Wiring Systems - Specifications, Component Views And Connector End Views) >> Diagnostic Information and Procedures >> Testing for Continuity >> With a Test Lamp
April 5, 2026: LEMON Manuals is launched! Read the announcement.

With a Test Lamp

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Only use the test lamp procedure on low impedance power and ground circuits.
  1. Remove the power feed (i.e. fuse, control module) from the suspect circuit.
  2. Disconnect the load.
  3. Connect 1 lead of the test lamp to 1 end of the circuit to be tested.
  4. Connect the other lead of the test lamp to battery positive voltage.
  5. Connect the other end of the circuit to ground.
  6. If the test lamp illuminates (full intensity), then the circuit has good continuity.
scientia non olet · About LEMON Manuals