LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2007 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 682 (Battery, Charging System And Starting System - Introduction) >> Repair Instructions >> Generator Battery Control Module Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

WARNING: This page is about a different car, the 2006 GMC Sierra, 2006 GMC Cab & Chassis Sierra, 2006 Chevrolet Silverado, and 2006 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the engine harness electrical connector from the generator battery control module.
    Fig 1: Disconnecting Engine Harness Electrical Connector From Generator Battery Control Module
    GM1484797Courtesy of GENERAL MOTORS CORP.
  2. Remove the negative battery cable. Refer to Battery Negative Cable Replacement (4.3L Engine) .
  3. Cut the tie straps and electrical tape attaching the generator battery control module to the battery cable.
  4. Squeeze the negative battery cable branches together.
    5. IMPORTANT: Note the orientation of the generator battery control module prior to removal.
  5. Slide the generator battery control module off of the negative battery cable.
scientia non olet · About LEMON Manuals