LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2007 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 727 (Power Steering System) >> Diagnostic Information and Procedures >> Scan Tool Data List >> Cycle Outputs
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Cycle Outputs

WARNING: This page is about a different car, the 2006 GMC Sierra, 2006 GMC Cab & Chassis Sierra, 2006 Chevrolet Silverado, and 2006 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

A scan tool may be used in order to command the EHPS pump speed enable message ON or OFF. This can be very helpful in determining if a certain portion of a circuit or a component is in working order. The following tests are available under the Special Functions selection. The following can be commanded ON or OFF:

Electro-Hydraulic Power Steering (EHPS) Scan Tool Data List

Scan Tool Parameter Data List Units Displayed Typical Data Value
Park brake set with the ignition switch ON/Ignition Switch in RUN/Automatic Transmission in PARK/Air Conditioning is OFF
Brake Pedal Travel Data mm -50 to 200 mm
BPP Sensor Rate Data ms 0 to +10%/25 ms
BPP Sensor Input Volts Data Volts 0 to 5 Volts
BPP Sensor Output Volts Data Volts 0 to 5 Volts
EHPS 42 V Bus Voltage Data Volts 0 to 76 Volts
EHPS Ignition 0 Data OFF/ON ON
EHPS Ignition 1 Data OFF/ON ON
EHPS Demand Data % -100 to +100%
EHPS Demand Speed Data RPM 0 to +7500 RPM
EHPS ECU Temperature Data °C -180 to +180°C (-238 to +302°F)
EHPS Manifold Temperature Data °C -180 to +180°C (-238 to +302°F)
EHPS Motor Current Data A 0 to +200 A
EHPS Motor RPM Data RPM 0 to +7500 RPM
Steering Wheel Rate Data °/s 0 to 2048°/s
Steering Wheel Sensor Phase A Volts Data Low/High Low
Steering Wheel Sensor Phase B Volts Data Low/High High
Vehicle Speed Data km/h 0