Installation Procedure
WARNING: This page is about a different car, the 2006 GMC Sierra, 2006 GMC Cab & Chassis Sierra, 2006 Chevrolet Silverado, and 2006 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Route the hose in the same position the hose occupied prior to removal.
- Install the power steering gear outlet hose (3) to the power steering pump (1).
Courtesy of GENERAL MOTORS CORP.
Position the clamp at the end of the hose.
- Install the power steering gear outlet hose to the power steering gear.
Tighten: Tighten the outlet hose fitting to 28 N.m (20 lb ft).
- Remove the drain pan from under the vehicle.
- Bleed the power steering system. Refer to Bleeding the Power Steering System .
NOTE:
Refer to INSTALLING HOSES WITHOUT TWISTS OR BENDS NOTICE
in Cautions and Notices.
NOTE:
Refer to FASTENER NOTICE
in Cautions and Notices.