LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2007 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 768 (Steering Linkage (Non-Rack & Pinion)) >> Repair Instructions >> Relay Rod Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2006 GMC Sierra, 2006 GMC Cab & Chassis Sierra, 2006 Chevrolet Silverado, and 2006 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Steering Linkage Components
    GM340481Courtesy of GENERAL MOTORS CORP.
  1. Install the relay rod (9) to the vehicle.
  2. Install the relay rod (9) to the pitman arm ball stud (2).
  3. Install the relay rod (9) to the idler arm ball stud (1).
  4. Ensure the seal is on the stud.
    5. Fig 2: Seating The Idler Arm Tapers
    GM689037Courtesy of GENERAL MOTORS CORP.
  5. Install the J 29193  or the J 29194  . See Special Tools .
    6. NOTE: Refer to Fastener Notice .
  6. Tighten the steering linkage installer in order to seat the tapers.

    Tighten:  Tighten the steering linkage installer to 54 N.m (40 lb ft).

  7. Remove the J 29193  or the J 29194  . See Special Tools .
  8. Install the new pitman arm prevailing torque nut.
  9. Install the new idler arm prevailing torque nut.

    Tighten:  Tighten the nuts to 62 N.m (46 lb ft).

  10. Install the tie rod ends. Refer to Tie Rod Replacement .
  11. Install the steering damper to the relay rod, if equipped. Refer to Steering Damper Replacement .
  12. Install the engine protection shield, if equipped. Refer to Engine Protection Shield Replacement .
  13. Lower the vehicle.
  14. Check the wheel alignment. Refer to Measuring Wheel Alignment .
scientia non olet · About LEMON Manuals