LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2007 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 910 (Lighting Systems) >> Diagnostic Information and Procedures >> DTC B3600 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON and clear the DTC. Use the scan tool Incandescent Dimming output control to adjust the dimming level of the I/P lamps from low to high.
    • If the lamps cannot be controlled with the scan tool, replace the BCM.
  2. Monitor the Dimming Control Signal voltage parameter in the scan tool BCM data list while adjusting the dimmer switch from high to low.
  3. If the voltage is above 4.97 volts, test for a short to voltage in the I/P lamp dimmer switch signal circuit.
    • If the circuit/connections test normal, replace the headlamp and panel dimmer switch.
  4. If the voltage drops below 0.10 volt, test for a short to ground, open, or high resistance in the I/P lamp dimmer switch signal circuit.
    • If the circuit/connections test normal, replace the headlamp and panel dimmer switch.
scientia non olet · About LEMON Manuals