Installation Procedure
WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Install the wheel speed sensor ring using the J 45860 (1) and the J 8092 (2). See Special Tools .
- Drive the wheel speed sensor ring into the axle housing until the tool bottoms against the tube.
- Install the axle shaft bearing using the J 23690 (1) and the J 8092 (2). See Special Tools .
- Drive the axle shaft bearing into the axle housing until the tool bottoms against the tube.
- Install the axle shaft seal using the J 21128 . See Special Tools .
- Drive the tool into the bore until the axle shaft seal bottoms flush with the tube.
- Install the axle shaft. Refer to Rear Axle Shaft Replacement (8.6, 9.5/9.5LD Inch Axles) or Rear Axle Shaft Replacement (8.6 Inch Axle w/Drum Brakes) .
- Install the rear axle housing cover. Refer to Rear Axle Housing Cover and Gasket Replacement .
- Install the rear wheel speed sensor. Refer to Rear Wheel Speed Sensor Replacement .
- Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
- Fill the rear axle. Refer to Rear Axle Lubricant Replacement (8.6 Inch Axle) or Rear Axle Lubricant Replacement (9.5 LD Axle) or Rear Axle Lubricant Replacement (9.5 Inch HD and 10.5 Inch Axles) .
- Lower the vehicle.