LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2007 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 958 (Trailer Brake Control System) >> Diagnostic Information and Procedures >> Scan Tool Data List
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Scan Tool Data List

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
TBCM Scan Tool Data List

Scan Tool Parameter Data List Units Displayed Typical Data Value
Operating Conditions: Ignition is ON, engine OFF, and vehicle is stationary
ABS Active TBCM Yes/No No
Brake Apply Pressure Status TBCM Invalid/Valid Valid
Battery Voltage Signal TBCM Volts B+
Brake Switch Status TBCM On/Off Off
Electric Trailer Brakes Detected TBCM Yes/No No
TBCM Diagnostic Fault TBCM Yes/No No
Ignition Run/Crank TBCM Active/Inactive Inactive
Low Speed Brake Hold TBCM Active/Inactive Inactive
Master Cylinder Pressure Sensor Input TBCM kPa/psi Varies
Manual Apply Switch TBCM % Varies
Manual Apply Switch Position Error TBCM % Varies
Redundant Manual Apply SW. TBCM % Varies
Trailer Brake Control TBCM Disabled/Enabled Enabled
TBCM Relay Feedback Signal TBCM Volts 12 Volts
Trailer Stop Lamp Signal TBCM Not Requested/Requested Not Requested
Trailer Brake Relay Cmd. TBCM Volts 12 Volts
TBCM Duty Cycle TBCM % Varies
Trailer Brake Relay Cmd. TBCM Volts 12 Volts
Trailer Brake Relay Status TBCM Disabled/Enabled Enabled
Trailer Connection Detected TBCM Yes/No No
Trailer Disconnect Detected TBCM Yes/No No
User Gain Switch TBCM % Varies
Vehicle Speed TBCM km/h or mph km/h or mph