Circuit/System Testing
WARNING: This page is about a different car, the 2007 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
With OnStar®
- Verify the OnStar® voice recognition is operating normally.
- If the OnStar® voice recognition is inoperative, refer to Voice Recognition Inoperative .
- Ignition OFF, disconnect the radio harness connector C3 and VCIM harness connector X3.
- Test for less than 1 volt on the C3 radio harness connector terminal 4.
- If greater than specified value, repair short to voltage.
- Test for greater than 1 ohm between the C3 radio harness connector terminal 4 and ground.
- If less than specified value, repair short to ground.
- Test for less than 1 ohm between the C3 radio harness connector terminal 4 and the C3 VCIM harness connector terminal 2.
- If greater than specified value, repair open circuit.
- Test for less than 1 volt on the C3 radio harness connector terminal 5.
- If greater than specified value, repair short to voltage.
- Test for greater than 1 ohm between the C3 radio harness connector terminal 5 and ground.
- If less than specified value, repair short to ground.
- Test for less than 1 ohm between the C3 radio harness connector terminal 5 and C3 VCIM harness connector terminal 4.
- If greater than specified value, repair open circuit.
- If all circuits test normal, replace the radio.