LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2007 >> STS Base, 3.6 7, AWD >> Repair and Diagnosis (Single Page) >> Steering >> Steering Wheel & Steering Column >> Repair Instructions >> Steering Wheel Heat Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. Install the module to the steering wheel.
    2. NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
    Fig 1: View Of Steering Wheel Heat Module Retaining Screws
    GM1390625Courtesy of GENERAL MOTORS CORP.
  2. Install the 2 retaining screws (1).

    Tighten:  Tighten the retaining screws to 5 N.m (44 lb in).

    3. Fig 2: View Of Steering Wheel Rear Shroud Screws
    GM1390622Courtesy of GENERAL MOTORS CORP.
  3. Install the rear shroud of the steering wheel.

    Tighten:  Tighten the retaining screws (1) to 4.5 N.m (40 lb in).

  4. Install the steering wheel. Refer to Steering Wheel Replacement .
scientia non olet · About LEMON Manuals