Class 2 Serial Data Circuit Right Hand Drive (RHD)
The class 2 serial data circuit on this vehicle consists of a hybrid ring and star configuration. Each module on the ring has 2 class 2 serial data circuits connected to it. If there is 1 open on the ring serial data communication will still take place. If there is more than 1 open on the ring, the modules not connected to the class 2 serial data circuit will not communicate. If there is 1 open on the star, the module not connected to the class 2 serial data circuit will not communicate. The following modules and splice packs are connected to the class 2 serial data circuit in a ring fashion:
- SP201
- SP303
- The inflatable restraint sensing and diagnostic module (SDM)
- SP300
- The dash integration module (DIM)
- The radio
- The HVAC control module
- The electronic control module (ECM)
- The electronic brake control module (EBCM)
- SP200
- The instrument panel cluster (IPC)
The star has the following 4 splice packs:
- SP201 located in the right side of the instrument panel, near the steering column, taped to the instrument panel harness.
- SP303 located in the right rear of the passenger compartment, taped to the body harness, approximately 24 cm (9.5 in) from the fuse block - right rear.
- SP300 located in the left side middle of the passenger compartment, taped to the body harness, near the carpet seam.
- SP200 located in the center of the instrument panel, near the radio.
The following devices are connected to the class 2 serial data circuit in star fashion via splice packs:
- SP201 - The DLC
- SP303
- The right rear door module (RRDM)
- The radio antenna module
- The TV antenna module
- The vehicle communication interface module (VCIM)
- The rear integration module (RIM)
- The memory seat module (MSM) w/A45
- The driver door module (DDM)
- The driver door switch assembly (DDSA)
- SP300
- The audio amplifier
- The left rear door module (LRDM)
- The front passenger door module (FPDM)
- SP200 - The theft deterrent control module
Refer to Data Link Connector (DLC) Schematics and the following illustration in order to familiarize yourself with the architecture of the class 2 serial data circuit: