Flash to Pass (FTP)

WARNING: This page is about a different car, the 2008 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.

When the low beam headlamps are on and the turn signal/multifunction switch is momentarily placed in the flash to pass (FTP) position, ground is applied from G201 to the turn signal/multifunction switch. The turn signal/multifunction switch applies ground to the body control module (BCM) through the FTP switch signal circuit. The BCM then applies ground to the high beam relay control circuit. This energizes the high beam relay, closing the switched side of the high beam relay, applying battery voltage to the LEFT and RIGHT HIGH BEAM fuses. Battery voltage is applied from the High Beam fuses through the high beam voltage supply circuit to the high beam headlamp assemblies. This causes the high beam headlamps to illuminate at full brightness momentarily.