Remote Control Door Lock Receiver (RCDLR)
- Battery Voltage Signal
-
The scan tool displays the battery voltage. The battery voltage input represents the system voltage measured at the module ignition feed input.
- Ignition Mode Switch
-
The scan tool displays the voltage and the state read by the module from the ignition mode switch.
- Ign. Mode Sw. Dimming Command
-
The scan tool displays the status of the ignition mode switch dimming.
- Ignition Switch Fault
-
The scan tool displays if the remote control door lock receiver (RCDLR) detected a fault on the ignition mode switch signal circuit.
- Invalid Power Moding
-
The scan tool displays if the RCDLR detects an invalid power moding.
- Back up Power Moding
-
The scan tool displays if back up power mode is active or not.
- Run/Crank Relay Command
-
The scan tool displays if the run/crank relay is controlled or not by the module.
- Run/Crank Relay Status
-
The scan tool displays the run/crank relay status.