LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2007 >> STS V >> Repair and Diagnosis (Single Page) >> Brakes >> Antilock Brake System, Traction Control System & Stability Control System >> Repair Instructions >> Electronic Brake Control Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: View Of EBCM & BPMV
    GM772017Courtesy of GENERAL MOTORS CORP.
  1. Clean the seal surface of the BPMV (2).
  2. Make sure that the internal pump motor connector (3) is installed into the new EBCM (1) prior to EBCM replacement.
  3. Install the EBCM (1) to the BPMV (2).
    4. Fig 2: Brake Pressure Modulator Valve
    GM782378Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  4. Install the 4 EBCM to BPMV screws.

    Tighten:  Tighten the 4 EBCM to BPMV screws in sequence (1-4) to 5 N.m (44 lb in).

    5. Fig 3: View Of EBCM, Electrical Connector & Connector Tab
    GM899235Courtesy of GENERAL MOTORS CORP.
    NOTE: To prevent equipment damage, never connect or disconnect the wiring harness connection from the EBCM with the ignition switch in the ON position.
  5. Connect the EBCM electrical connector (1) to the EBCM (3).
  6. Rotate the EBCM connector tab (2) rearward to the locked position.
  7. Install the washer solvent containert. Refer to Washer Solvent Container Replacement (w/o CE4) or Washer Solvent Container Replacement (w CE4) .
  8. Install the air deflector shield. Refer to Front Air Deflector Replacement .
  9. Lower the vehicle.
  10. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  11. If installing a new EBCM it is necessary to program the EBCM. Refer to Control Module References .
  12. Perform the Diagnostic System Check - Vehicle. Refer to Diagnostic System Check - Vehicle .
scientia non olet · About LEMON Manuals