LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2007 >> STS V >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Front End Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2006 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Inflatable Restraint Front End Sensor
    GM1452885Courtesy of GENERAL MOTORS CORP.
  1. Remove any dirt, grease, or other impurities from the mounting surface.
  2. Position the sensor horizontally on the mounting surface.
  3. Point the arrow on the sensor toward the front of the vehicle.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the mounting fasteners.

    Tighten:  Tighten the fastener to 9 N.m (80 lb in).

  5. Connect the harness wiring connector to the front end sensor.
  6. Install the CPA to the wiring harness connector on the front end sensor.
  7. Reposition the radiator.
  8. Install the radiator sight shield.
  9. Enable the SIR system. Refer to SIR Disabling and Enabling .
scientia non olet · About LEMON Manuals