Programming the GDO for Rolling Code Receivers

This procedure is for training the customer's rolling code garage door openers to their GDO transmitter. The training process below must be completed within 30 seconds or it must be repeated.

1. Press the two outside buttons on the GDO for one to two seconds and immediately release them.
2. Locate the train button on the garage door opener receiver. Refer to the operator's manual for the garage door opener (or call 1-866-572-2728 for assistance). Follow instructions for the garage door opener in order to determine when the unit is in train mode.
3. Return to the GDO transmitter in the vehicle, and press the button that you want trained for rolling codes 5 to 20 seconds. The LED above the button will flash slowly. When the garage door moves, release the button. The LED will then flash rapidly until programming is complete.
4. Press the button used again in order to verify that the GDO transmitter has been programmed.

You may use either the hand-held transmitter or the GDO to open the garage door.

The GDO is compatible with most, but not all, types of garage door openers. If the GDO light does not flash rapidly after 90 seconds, there may be a compatibility conflict with the garage door opener. Call 1-866-572-2728 in order to address compatibility concerns.