LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2007 >> STS V >> Repair and Diagnosis >> External Pages >> Different car >> Section 161 (Antilock Brake System, Traction Control System & Stability Control System) >> Repair Instructions >> Electronic Brake Control Module Replacement (CTS-V) >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of EBCM & BPMV
    GM772017Courtesy of GENERAL MOTORS CORP.
  1. Clean the seal surface of the BPMV.
  2. Install the EBCM (1) to the BPMV (2).
  3. Make sure that the internal pump motor connector (3) is installed into the new EBCM (1) prior to EBCM replacement.
    4. NOTE: Refer to Fastener Notice .
    Fig 2: Installing EBCM To BPMV Screws
    GM782378Courtesy of GENERAL MOTORS CORP.
  4. Install the EBCM to BPMV screws.

    Tighten:  Tighten the (4) EBCM to BPMV screws in sequence (1-4) to 5 N.m (44 lb in).

    5. Fig 3: View Of EBCM And Electrical Connector
    GM899234Courtesy of GENERAL MOTORS CORP.
    NOTE: To prevent equipment damage, never connect or disconnect the wiring harness connection from the EBCM with the ignition switch in the ON position.
  5. Connect the EBCM electrical connector (1) to the EBCM (3).
  6. Rotate the EBCM connector tab (2) to the locked position.
  7. Install the front air deflector. Refer to Front Air Deflector Replacement .
  8. Lower the vehicle.
  9. Use the scan tool in order to clear the DTCs.
  10. If installing a new EBCM, program the EBCM. Refer to Control Module References .
  11. Perform the Diagnostic System Check - Vehicle. Refer to Diagnostic System Check - Vehicle .
  12. Recalibrate the brake pedal position sensor. Refer to Brake Pedal Position Sensor Calibration .
scientia non olet · About LEMON Manuals