LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2007 >> STS V >> Repair and Diagnosis >> External Pages >> Different car >> Section 262 (Programming And Setup - All Systems) >> Repair Instructions >> Electronic Suspension Control Module Programming and Setup >> ESCM Programming
April 5, 2026: LEMON Manuals is launched! Read the announcement.

ESCM Programming

WARNING: This page is about a different car, the 2007 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.

If the ESCM is reprogrammed, the procedures must be performed in the following order:

  1. The ESCM reprogramming, refer to Service Programming System (SPS) .
  2. The bumpstop setup procedure. To perform this procedure, lift the vehicle just off the ground to fully extend the suspension. Connect the scan tool to the vehicle, turn ignition ON with the engine OFF, and follow the on screen instructions in ESC Special Functions.
    IMPORTANT: The vehicle must be at correct trim height and on a level surface before performing trimset procedure. Refer to Trim Height Inspection .
  3. The trimset procedure. Connect the scan tool to the vehicle, turn ignition ON with the engine OFF, and follow the on screen instruction in the ESC Special functions.
scientia non olet · About LEMON Manuals