Inflatable Restraint Sensing and Diagnostic Module Programming and Setup
WARNING: This page is about a different car, the 2007 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
The air bag indicator light may remain ON after the body control module (BCM), or inflatable restraint sensing and diagnostic module (SDM) is replaced, and during the programming procedure for the BCM until after the procedure is completed. When installing a new SDM, there may be several DTC's set prior to programming. Once programmed, these DTC's should be in history and can be cleared.
IMPORTANT:
If the SDM was replaced, the SIR warning indicator will remain ON SOLID until after the programming event is complete.
- Key ON, Engine OFF. Program the SDM, refer to Service Programming System (SPS) .
- In the BCM Module Setup menu, select Setup SDM Primary Key in BCM. Follow the scan tool on screen instructions.
- In the SDM Module Setup menu, select Setup SDM. Follow the scan tool on screen instructions..
- Cycle the ignition from OFF to ON. Verify no DTCs are set. If any DTCs are set, refer to DIAGNOSTIC TROUBLE CODE (DTC) LIST - VEHICLE .