LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2007 >> STS V >> Repair and Diagnosis >> External Pages >> Different car >> Section 372 (Data Communication System) >> Repair Instructions >> Data Link Connector Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac XLR. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing DLC & Screws
    GM652086Courtesy of GENERAL MOTORS CORP.
  1. Position the data link connector to the instrument panel.
    2. NOTE: Refer to Fastener Notice .
    NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  2. Install the screws to the data link connector.

    Tighten:  Tighten the data link connector screws to 2 N.m (18 lb in).

scientia non olet · About LEMON Manuals