Circuit/System Testing
WARNING: This page is about a different car, the 2010 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the EBCM.
- Ignition OFF and all vehicle systems OFF. It may take up to 2 minutes for all vehicle systems to power down. Test for less than 10 Ω between the ground circuits listed below and ground:
- Terminal 1
- Terminal 25
- If greater than the specified range, test the ground circuit for an open/high resistance.
- Ignition ON, verify that a test lamp illuminates between the B+ circuits listed below and ground:
- Terminal 13
- Terminal 38
- If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.
- If all circuits test normal, replace the EBCM.