LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2007 >> XLR Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Anti-Theft Systems >> Power Door Lock System And Release Systems >> Diagnostic Information and Procedures >> Trunk Release Inoperative >> Circuit/System Testing >> Trunk Release Inoperative from Lid Close Switch
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Trunk Release Inoperative from Lid Close Switch

  1. Ignition OFF, disconnect the harness connector at the rear compartment lid/release close switch.
  2. Ignition ON, verify that a test lamp illuminates between the B+ circuit terminal D and ground.
    • If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance. If the circuit tests normal and the B+ circuit fuse is open, test the signal circuit terminal A for a short to ground.
  3. Verify the scan tool rear compartment lid pull down switch is INACTIVE.
    • If not the specified value, test the signal circuit terminal A for a short to voltage. If the circuit tests normal, replace the folding top control module.
  4. Install a 3A fused jumper wire between the signal circuit terminal A and the B+ circuit terminal D. Verify the scan tool rear compartment lid pull down switch is ACTIVE.
    • If not the specified value, test the signal circuit for an open/high resistance. If the circuit tests normal, replace the folding top control module.
  5. If all circuits test normal, test or replace the rear compartment lid/release close switch.
scientia non olet · About LEMON Manuals