LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2007 >> XLR Base >> Repair and Diagnosis (Single Page) >> Steering >> Steering Wheel & Steering Column >> Repair Instructions >> Steering Column Lock Control Module Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

    Fig 1: Identifying Steering Column Electronic Lock Harness
    GM1400455Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to SIR Caution .
  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
    2. NOTE: Avoid damaging the steering column electronic lock harness by gently removing the plugs installed in the I/P beam. Do NOT twist, pull, bend, cut or incorrectly route the harness. Damage to the harness will require replacement of the entire electronic lock.
  2. Remove the instrument panel (I/P) carrier. Refer to Instrument Panel Carrier Replacement .
  3. Disconnect the electrical connectors at the lock module.
    4. Fig 2: Identifying The Lock Module In The I/P Carrier
    GM1400454Courtesy of GENERAL MOTORS CORP.
  4. Remove the lock module by pulling the module up to release the retaining clips and sliding the module upward.
scientia non olet · About LEMON Manuals