Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Yaw Rate Sensor/Lateral Accelerometer & Mounting Nuts

Courtesy of GENERAL MOTORS CORP.

Install the yaw rate sensor/lateral accelerometer (1).

NOTE: Refer to Fastener Notice .

Install the 2 nuts (2) to the accelerometer.
Tighten: Tighten the nuts to 9 N.m (80 lb in).

Fig 2: View Of Yaw Rate Sensor/Lateral Accelerometer & Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connector (2) to the accelerometer (1).
Perform the ABS Diagnostic System Check. Refer to Diagnostic System Check - Vehicle .