LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2007 >> XLR Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Wiper System & Washer System) >> Repair Instructions >> Wiper Motor Module Grommet Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the following wiper motor module grommets:
    • Round (2)
    • Oval (6)
    • Pin (7)
    2. Fig 1: View Of Windshield Wiper Motor Components
    GM776830Courtesy of GENERAL MOTORS CORP.
  2. Place the wiper motor module into the vehicle.
  3. Connect the wiper motor module electrical connector (4).
  4. Align the wiper module locator hole (7) to the pin located inside rail of the driver side fender.
  5. Align the locator hole (6) to the hole in the pillar flange.
    6. NOTE: Refer to Fastener Notice .
  6. Install the outer fastener (5).

    Tighten:  Tighten the outer fastener to 10 N.m (89 lb in).

  7. Install the center fastener (3).

    Tighten:  Tighten the center fastener to 10 N.m (89 lb in).

  8. Install the air inlet grille. Refer to Air Inlet Grille Panel Replacement .
  9. Install the wiper arm assemblies. Refer to Windshield Wiper Arm Replacement .
  10. Install the wiper motor fuse in the underhood fuse block.
scientia non olet · About LEMON Manuals